 |
| Quantity: | |
|---|---|
25.6V50ah
UGA POWER
8507600010
This LiFePO4 pack supplies autonomous power for scrubbers, sweepers and other listed equipment. The specification table identifies a 25.6V52Ah model with built-in BMS and Bluetooth monitoring. Its 329 × 172 × 233mm plastic housing weighs 13.5kg.
Use the actual 25.6V nominal voltage when reviewing compatibility. Confirm the ordered 52Ah configuration, since the listing also uses a 50Ah model reference. Machine voltage limits, connector geometry and battery-compartment clearance should be resolved together.
25.6V52Ah pack data
Parameter | Value |
|---|---|
Battery model | 25.6V52Ah |
Voltage | 25.6V |
Capacity | 52AH |
Max continuous discharge current, A | 50A |
Max continuous charge current, A | <25A |
Impulse discharge current, A | max 120A not more than 2s |
No of cycle DoD80% 25С, discharge 0,5C | >=3000 |
BMS | yes, control overdischarge, temperature, charge, short circuit |
Monitoring possibility | Yes, by means Bluetooth. State of charge, V, A, T |
Charging Temp., | 0+45℃ |
Operation ambient Temp. | - 20 + 60℃ |
L B H, mm | 329*172*233 |
Weight, kg | 13.5 |
Box material | plastic |
CAN communication between charger and battery | No |
IP | IP65 |
Possibility to connect in parallel | Yes, at least 2 |
Charger recommended | 29,2V 20A |
Selection note: Model and branding: the table specifies 25.6V52Ah; the summary uses 25.6V50ah and the brand field reads UGA POWER. Confirm the ordered configuration and label before supply.
The pack is specified for 50A continuous discharge. Its impulse ceiling is 120A for no more than two seconds. Cleaning-machine assessment should separate normal brush and traction loads from brief starting demands, then compare both with these limits.
The built-in BMS controls overdischarge, temperature, charging and short-circuit conditions. These functions support pack management, but the machine still needs a compatible electrical design. Buyers should provide controller and charger requirements for the proposed installation.
Bluetooth monitoring makes state of charge, voltage, current and temperature available. These readings help operators review battery condition during equipment use. No particular app name, remote fleet platform or communication range is specified.
The recommended charger is 29.2V 20A, while maximum continuous charging current is listed below 25A. The pack does not provide CAN communication between charger and battery. Confirm that the intended machine does not depend on that interface.
Charging is specified from 0°C to 45°C; the operating ambient range is −20°C to 60°C. The plastic box has an IP65 rating. Installation planning should address the actual cleaning environment and connector exposure without treating IP65 as approval for immersion.
The cycle entry is at least 3000 cycles at 80% depth of discharge, 25°C and 0.5C discharge. Parallel connection is listed as supported, with at least two packs referenced. Obtain the approved pack count and wiring arrangement before designing a larger bank.
FOBERRIA provides battery solutions for cleaning equipment, mobile pallet wrappers, mini electric transport vehicles, electric boats and energy storage systems. For machines requiring a different battery configuration, the LiFePO4 battery range for cleaning equipment can serve as a reference for evaluating alternative pack options.
For this machine conversion, provide the motor current requirements, charging conditions, physical clearances, and required interfaces to FOBERRIA through its battery project contact page to discuss a suitable battery solution.
The detailed model is 25.6V52Ah: 25.6V is nominal voltage and 52Ah is capacity. The listing uses 24V-class and 50Ah wording elsewhere, so the purchase specification should state the intended 52Ah version.
The 25.6V52Ah specification gives 50A continuously and up to 120A for at most two seconds. Compare motor startup and sustained working demand separately.
A 29.2V 20A charger is recommended. The charge-current ceiling is below 25A, and the listed charging temperature window is 0°C to 45°C.
No. The 25.6V52Ah table explicitly lists no CAN communication between charger and battery. Bluetooth is provided for state of charge, voltage, current and temperature monitoring.
The ≥3000-cycle reference applies at 80% depth of discharge, 25°C and 0.5C discharge. It should not be presented as the same cycle result under every operating condition.
Parallel operation is listed as possible, with at least 2 packs referenced. The maximum permitted quantity and installation details should be confirmed for the specific battery bank.
